Pioneer Toraiz SQUID - Creative Multitrack Sequencer - Manual (Page 54)

Step edit section
54
En
2 Continue to hold down the pad and press the rotary selector.
Repeatedly pressing the rotary selector switches between the unmuting state
and muting state. The unmuting/muting state is shown on the display.
• White square (

): Unmuted
• Black square (  ): Muted
3 Continue to hold down the pad and turn the [PITCH/CC1] , [GATE/
CC2] , or [VELOCITY/CC3] knob, or press the [  ] / [  ] button.
The note information will be shown on the display and you can set the
corresponding parameters as follows.
• [PITCH/CC1] knob: PITCH value
• [GATE/CC2] knob: GATE value
• [VELOCITY/CC3] knob: VELOCITY value
• [  ] / [  ] button: OFFSET value
4 Repeat step 1 to 3.
Notes
• While performing the operations above for [Notes] to perform settings after
setting a polyphonic note, you can change the parameters of all the notes
included in the pad at once.
• While holding down multiple pads and performing the operations above, you
can change the parameters of all the pads that are held down at the same
time. At this time, you cannot switch a note to set by turning the rotary
selector.
• While not holding down any pad and performing the operations above, you
can change the parameters of all the pads in the current pattern at the same
time. At this time, you cannot switch a note to set by turning the rotary
selector.