Pioneer Toraiz SQUID - Creative Multitrack Sequencer - Manual (Page 129)

Changing the settings
129
En
 OUT Polarity
Setting value: − , +*
Set the polarity of the [CLOCK OUT] terminal. − is falling and + is
rising.
Check the specification of the connected equipment and select an
appropriate value.
• − :
Select when the connected equipment triggers the pulse of the timing
clock in falling (negative edge trigger).
• +:
Select when the connected equipment triggers the pulse of the timing
clock in rising (positive edge trigger).
 IN Sync Mode
Setting value: 1step, 1ppqn, 2ppqn, 4ppqn, 24ppqn*, 48ppqn, Gate
Set the timing clock rate from the
[CLOCK IN] terminal.
Check the specification of the connected equipment and select an
appropriate value.
• 1step:
Timing clock rate of 1 Pulse Per Step
A pattern is advanced by one step when 1 pulse is input to the timing
clock.
• 1ppqn:
Timing clock rate of 1ppqn (Pulse Per Quarter Note)
1 pulse of the input timing clock is counted as one beat (one quarter
note).
• 2ppqn:
Timing clock rate of 2ppqn (Pulse Per Quarter Note)
1 pulse of the input timing clock is counted as 1/2 beat (Eighth note).
• 4ppqn:
Timing clock rate of 4ppqn (Pulse Per Quarter Note)
1 pulse of the input timing clock is counted as 1/4 beat (16 minute
note).