Pioneer Toraiz SQUID - Creative Multitrack Sequencer - Manual (Page 68)

Step edit section
68
En
• When there are multiple notes for a step, the operation is as follows:
– PITCH:
The PITCH value which is interpolated is applied to
Note 1. The PITCH values for Note 2 to 8 are not
applied.
– GATE: GATE value which is interpolated is applied to all
notes.
– VELOCITY: VELOCITY value which is interpolated is applied to all
notes.
• For the note applied with interpolation, the OFFSET value is set to 0.
Using INTERPOLATION
1 Press the [PITCH] , [GATE] , or [VELOCITY] button.
The pressed button lights up in orange.
• When Trigger mode is selected at the end, you can interpolate the PITCH,
GATE, or VELOCITY value.
• When CC mode is selected at the end, you can interpolate the control value
of CC1, CC2, or CC3.
2 Hold down the pad to set the beginning, middle, or end point for the
interpolation, and turn the knob at the right of the button pressed in
step 1.
The display shows the value of the parameter. The pads where the beginning,
middle, and end points were set light up in white.
• In addition up to 5 points (beginning, end and up to 3 middle points) can be
inserted.
• To delete the beginning, middle, or end point, press the pad where the step
including the point is. The light of the pad dims.