Pioneer Toraiz SQUID - Creative Multitrack Sequencer - Manual (Page 174)

Additional information
174
En
• To use the audio signal as a trigger signal, input sound with
sufficiently high volume that has sharp attack/decay, like pulse signal
and click sound.
• To control the unit by the audio signal, see [IN Sync Mode]
(page 129) of [CLOCK] setting in the GLOBAL menu.
 The slave device (the unit) cannot be controlled from a master
device (equipment connected to the unit).
• Check that the [USB-B] , [MIDI IN] , [CLOCK IN] , or [DIN SYNC IN/
OUT2] terminal where [OUT2 Mode] (page 126) of [DIN Sync]
setting in the GLOBAL menu is set to [IN] is connected correctly to a
master-clock transmitter.
• Set [Sync Source] (page 124) of the [Sync Common] setting in the
GLOBAL menu correctly.
Set
[IN Sync Mode] (page 129) of [CLOCK] setting correctly in
accordance with the connected device when [CLOCK] is set.
Set [OUT2 Sync Mode] (page 126) of [DIN Sync] setting correctly
in accordance with the connected device when [DIN SYNC] is set.
 Equipment connected to the [CV OUT1], [CV OUT2], [GATE
OUT1], or [GATE OUT2] terminal does not work.
• See “Connecting the unit to an external CV/GATE compatible device
to play” (page 158).
 The device connected to the [CV OUT1] or [CV OUT2] terminal
does not produce notes with correct pitch.
• Check if the Coarse and Fine are set correctly on the connected
device. Since CV is a pitch control signal by analog voltage, it may
not be possible for the receiving device to produce note with the
correct pitch depending on the temperature. In that case, adjust the
pitch with the Fine setting of the receiving device.