Pioneer Toraiz SQUID - Creative Multitrack Sequencer - Manual (Page 48)

Step edit section
48
En
The parameters used for TRIGGER mode
You can set the following parameters included in each pad (step) and
each note in Trigger mode.
 The parameters included in each note (note information)
The following parameters can be set to each note.
• PITCH value:
Adjusts the pitch of a note.
The setting range is
[C-1] to [G-9] . The default value is [C4] .
• GATE value:
Adjusts the length of a note.
The setting range is
[0.125step] to [64.000step] . The default value
is [1.000step] .
• VELOCITY value:
Sets the strength and weakness of a note.
The setting range is
[0] to [127] . The default value is [100] .
• OFFSET value:
Adjusts the timing of notes triggered.
Normally a note is triggered at the same time as the steps proceed;
however, the trigger timing can be delayed up to 5/6 step in 1/6 step
units. In the default setting, a note is triggered at the same time as a
step proceeds.
(1) 1 step, (2) Note, (3) OFFSET value
0 1 5