PLANET WNAP-1110 - Manual (Page 69)

User’s Manual of WNAP-1110
-69-
Beacon Intervals. The default value is 1, which indicates the DTIM Interval is
the same as Beacon Interval.
Enable WMM WMM function can guarantee the packets with high- priority messages being
transmitted preferentially. It is strongly recommended enabled.
Enable Short GI This function is recommended for it will increase the data capacity by
reducing the guard interval time.
Enabled AP Isolation This function can isolate wireless stations on your network from each other.
Wireless devices will be able to communicate with the AP but not with each
other. To use this function, check this box. AP Isolation is disabled by default.
If you are not familiar with the setting items on this page, it's strongly recommended to keep
the provided default values; otherwise, it may result in low wireless network performance.
5.6.5 Antenna Alignment
The Align Antenna utility allows the user to point and optimize the antenna in the direction of the maximum link
signal. Choose menu “Wireless→Antenna Alignment”, and you can align the remote site by reference to the
RSSI value of the remote AP. You can observe the remote AP’s signal strength changes while changing the
antenna's direction.
Figure 5-49 Antenna Alignment
The page includes the following fields:
Object Description
Remote AP RSSI Remote AP's signal strength value.
Signal percent The ratio of RSSI to RSSI RANGE in percentage.