PLANET WNAP-1110 - Manual (Page 17)

User’s Manual of WNAP-1110
-17-
Chapter 3. Connecting the AP
3.1 System Requirements
Broadband Internet Access Service (DSL/Cable/Ethernet connection)
One DSL/Cable Modem that has an RJ-45 connector (not necessary if the AP is connected directly to
the Ethernet.)
PCs with a working Ethernet adapter and an Ethernet cable with RJ-45 connectors
Subscribers can utilize Windows 98/ME, NT4.0, 2000/XP, Windows Vista / Win 7, MAC OS 9 or later,
Linux, UNIX or other platforms compatible with TCP/IP protocols
The above PC is installed with a Web browser
It is recommended to use Internet Explore 7.0 or above to access the AP.
3.2 Installing the AP
Before installing the AP, make sure your PC is connected to the Internet through the broadband service
successfully at this moment. If there is any problem, please contact your local ISP. After that, please install the
AP according to the following steps. Don't forget to pull out the power plug and keep your hands dry.
Step 1. Power off your PC, Cable/DSL Modem, and the AP.
Step 2. Locate an optimum location for the AP. The best place is usually at the center of your wireless
network.
Step 3. Adjust the direction of the antenna. Normally, upright is a good direction.