PLANET WNAP-1110 - Manual (Page 59)

User’s Manual of WNAP-1110
-59-
Object Description
Wireless Network Name
(SSID)
Enter a value of up to 32 characters. The same name of SSID (Service Set
Identification) must be assigned to all wireless devices in your network.
Considering your wireless network security, the default SSID is set to be
WNAP-1110. This value is case-sensitive. For example, PLANET is NOT the same
as planet.
Region Select your region from the pull-down list. This field specifies the region where the
wireless function of the AP can be used. It may be illegal to use the wireless
function of the AP in a region other than one of those specified in this field. If your
country or region is not listed, please contact your local government agency for
assistance. Please be note that selecting the incorrect country may cause
interference to other devices and violate the applicable law.
Channel This field determines which operating frequency will be used. The default channel
is set to Auto, so the AP will choose the best channel automatically. It is not
necessary to change the wireless channel unless you notice interference
problems with another nearby access point.
Mode Select the desired mode. The default setting is 11bgn mixed.
11b only, 11g only, 11n only, 11bg mixed, 11bgn mixed.
It is strongly recommended that you set the Mode to 802.11b&g&n, and all of
802.11b, 802.11g, and 802.11n wireless stations can connect to the AP.
Channel width Select any channel width from the pull-down list. The default setting is Auto, which
can adjust the channel width for your clients automatically.
Enable Wireless Radio The wireless radio of this AP can be enabled or disabled to allow wireless stations
access.
Enable SSID Broadcast When wireless clients survey the local area for wireless networks to associate
with, they will detect the SSID broadcast by the AP. If you select the Enable SSID
Broadcast checkbox, the Wireless AP will broadcast its name (SSID) on the air.
If 11b only, 11g only, or 11bg mixed is selected in the Mode field, the Channel Width selecting field
will turn grey and the value will become 20M, which is unable to be changed.