PLANET WNAP-1110 - Manual (Page 18)

User’s Manual of WNAP-1110
-18-
Figure 3-1 Adjust the direction of the antenna
Step 4. Connect the Power Source to the WNAP-1110. Only choose one of the following methods for the
suitability of AP’s location; otherwise, it will cause damage to the WNAP-1110.
Method A -- Hard to find the power socket
(1) Connect the Ethernet cable to the LAN port of the PC, and plug the other end of the Ethernet cable into the
LAN port of the PoE injector.
(2) Use another Ethernet cable (8-wire patch cable) to connect the LAN port of the WNAP-1110 and the PoE
port of the PoE Injector.
※ The 8-wire patch cable should not exceed 30 meters in length.
(3) Connect the power adapter to the DC port of the PoE injector, and plug the other end of the power adapter
into an electrical outlet.
Method B -- Power Socket nearby
(1) Connect the Ethernet cable to the LAN port of the PC, and plug the other end of the Ethernet cable into the
LAN port of the WNAP-1110.
(2) Connect the power adapter into the POWER port of the WNAP-1110 in the rear panel, and plug the other
end of the power adapter into an electrical outlet.