PLANET WNAP-1110 - Manual (Page 35)

User’s Manual of WNAP-1110
-35-
other.
VLAN ID (1-4) Provide a number between 1 and 4095 for VLAN. This will cause the AP to send
packets with VLAN tags. The switch connecting with the AP must support VLAN
IEEE802.1Q frames. The wireless stations connecting to the SSID of a specified
VLANID can communicate with the PC connecting to the port with the same
VLANID on the Switch.
Channel Determines the operating frequency to be used. It is not necessary to change the
wireless channel unless you notice interference problems with another nearby
access point.
Mode This field determines the wireless mode which the device works on.
11b only - Only 802.11b wireless stations can connect to the AP.
11g only - Only 802.11g wireless stations can connect to the AP.
11n only - Only 802.11n wireless stations can connect to the AP.
11bg mixed - Both 802.11b and 802.11g wireless stations can connect to the AP.
11bgn mixed - All 802.11b, 802.11g and 802.11n wireless stations can connect to
the AP.
Channel Width Determines the channel width to be used. It is unnecessary to change the default
value unless required.
Enable Wireless Radio Select or deselect this check box to allow or deny wireless stations to access the
AP.
Enable SSID Broadcast Select or deselect this check box to allow or deny the AP to broadcast its name
(SSID) on the air. If it’s allowed, when wireless clients survey the local area for
wireless networks to associate with, they will detect the SSID broadcast by the
AP.
You are suggested to implement Multi-SSID function with a switch that supports Tag VLAN feature.