RIGOL MSO/DS2000A Series - Manual (Page 52)

RIGOL Chapter 1 Quick Start
1-24 MSO2000A/DS2000A User’s Guide
14. CH2 Vertical Scale
Display the voltage value per grid of CH2 waveform vertically. In addition, the
following labels will be displayed according to the current channel setting:
channel coupling (e.g. ), input impedance (e.g. ) and bandwidth limit (e.g.
). You can use VIRTICAL SCALE to modify this parameter.
15. Digital Channel Status Area
Display the current status of the 16 digital channels (D0 to D15 from right to
left). The digital channels currently turned on are displayed in green, the digital
channel currently selected is displayed in red and the digital channels currently
turned off are displayed in grey.
Note: This function is only applicable to MSO2000A and MSO2000A-S models
oscilloscopes.
16. Message Box
Display the prompt messages.
17. Source1 Waveform
Display the type of the waveform currently selected by Source1.
 When the impedance of the signal source is set to 50 Ω, will be
displayed at the right of the Source1 waveform.
 When the modulation is enabled, will be displayed at the right of the
Source1 waveform.
Note: This function is only applicable to MSO2000A-S and DS2000A-S models
oscilloscopes.
18. Source2 Waveform
Display the type of the waveform currently selected by Source2.
 When the impedance of the signal source is set to 50 Ω,
will be
displayed at the right of the Source2 waveform.
 When the modulation is enabled, will be displayed at the right of the
Source2 waveform.
Note: This function is only applicable to MSO2000A-S and DS2000A-S models
oscilloscopes.
19. Notification Area
Display the system time, sound icon and USB storage device icon.