RIGOL MSO/DS2000A Series - Manual (Page 225)

Chapter 13 Signal Source RIGOL
MSO2000A/DS2000A User’s Guide 13-1
Chapter 13 Signal Source
MSO2000A/DS2000A combines the signal generator and oscilloscope in one
instrument by providing a built-in dual-channel, 25MHz signal generator, thus
providing convenience for engineers who need to use the signal generator and
oscilloscope at the same time. This chapter introduces how to use the built-in signal
generator. As the functions and setting methods of source 1 and source 2 are same,
this chapter takes Source 1 for illustration.
Press Source to enter the signal generator setting interface.
 Press Source1 to enable or disable the signal output. When it is enabled, the
[Source1] connector at the rear panel outputs signal according to the current
setting.
Note: The function of Source  Source1 is the same with that of Source 
Setup1  Source.
 Press Setup1 to set the type and parameters of the signal output from
[Source1].
 Press Status to view the parameter settings of Source 1 and Source 2, such as
the frequency, amplitude and offset, as shown in the figure below.
Figure 13-1 Signal Source Status
The contents of this chapter:
 Parameter Setting Method
 To Output Basic Waveform
 To Output Built-in Waveform
 To Output Arbitrary Waveform
 Modulation