RIGOL MSO/DS2000A Series - Manual (Page 212)

RIGOL Chapter 11 Waveform Record
11-6 MSO2000A/DS2000A User’s Guide
Waveform Playback
Waveform playback can play back the waveforms currently recorded. After recording
the waveforms, press Utility  Record  Mode and use
to select “Play back”.
At this point, the information as shown in the figure below is displayed at the upper
right corner of the screen, indicating the specific frame currently displayed on the
screen. During the playback, this value would change continuously.
Please refer to the following descriptions to set the playback parameters.
1. Play Mode
Press this softkey to set the playback mode to cycle or single.

: cycle playback. Play from the start frame to the end frame and then
repeat until you stop it manually.
 : single playback. Play from the start frame to the end frame and
then stop.
2. Interval
Press this softkey and use to set the time interval of playback. The range
availbale is from 100 ns to 10 s and the default is 100 ns.
3. Start Frame
Press this softkey and use to set the start frame of playback. The default is 1
and the maximum is the maximum number of frames recorded.
4. Current Frame
Press this softkey and use or the navigation knob (large scale adjustment)
to set the current frame. By default, the current frame is the same with the end
frame. The setting range of current frame is related to the start frame and end
frame settings. During the setting, the screen will display the corresponding
waveform of the current frame synchronously, namely manual playback.
If you perform the playback operation after setting this parameter, this menu will
be adjusted to the start frame value automatically and will change continuously
during the playback process.