RIGOL MSO/DS2000A Series - Manual (Page 239)

Chapter 13 Signal Source RIGOL
MSO2000A/DS2000A User’s Guide 13-15
2. Interpolation
Press Interp to turn on or off the interpolation mode between the points of the
waveform.
 ON: the waveform editor connects two points using a straight line.
 OFF: the waveform editor will keep a constant voltage level between the
two points and create a ladder-like waveform.
3. Zoom
Press Zoom to turn on or off the zoom function.
 ON: the waveform editing window only displays the current point.
 OFF: the waveform editing window displays all the initial points.
4. Current Point
Press Current and use or the navigation knob to select the point to be
edited. The range is from 1 to the initial points. For the setting method, please
refer to the introduction in “Parameter Setting Method”.
5. Voltage
Press Voltage and use or the navigation knob to set the voltage of the
current point. The range is from -2.5 V to +2.5 V. For the setting method, please
refer to the introduction in “Parameter Setting Method”.
6. Time
Press Time and use or the navigation knob to set the duration of the current