RISCO Group ACUS User Manual
Page 270
User Manual for ACUS
Uncontrolled
when
printed
©
RISCO
Group
242
Figure 247: Add Events
3. The default event name appears in the Event Behavior field. Enter the name of the
event for which you want to configure settings as per your requirement.
4. Select the event category name from the Event Category drop-down list. The event
categories are Door, Sensors, Zone, System and Person Card events. Based on the
event category selected, the Event Types will be generated.
5. Select the event type from the Event Type drop-down list. The default events for each
category are reflected here. For details on Event Types, refer to
B
Events and Alarms
Icons
.
6. From
the
Applied to drop-down list, select the filter which would be applied to the
event.
Note: If the required filter is not available in the list, then click
next to the Applied To drop-
down list. The Filter Edit dialog box appears where you may add a new filter. For details,
refer to
19.2.1 Add Event Filter
.
The event settings tab is divided in three areas, Event Settings, Alarm Settings and Execute
Automation. In the event settings area, perform the following steps:
7. Select
the
Create an Alarm check box to display an alarm alert message when the
event occurs. After you select the check box, the Alarm Settings and Alarm
Procedures tab appear next to the Event Settings tab. The Alarms Settings area is
enabled.