Extreme Networks Summit1 - Manual (Page 84)

4-12 S UMMIT S WITCH I NSTALLATION AND U SER G UIDE
C ONFIGURING P ORTS
S UMMIT V IRTUAL C HASSIS C OMMANDS
Table 4-9 lists commands that are used on the Summit switch to connect it to a Summit
Virtual Chassis.
C ONFIGURING THE S UMMIT FOR U SER WITH THE S UMMIT V IRTUAL
C HASSIS
You must configure the Summit switch port(s) prior to connecting the switch to the
Summit Virtual Chassis. Each connected port must be configured as a SummitLink port,
using the following command:
enable summitlink port
If you are using a parallel Virtual Chassis stack, you must configure load-sharing on the
Summit after the ports are designated as SummitLink ports. This is done using the
following command:
enable sharing grouping
Table 4-9: Summit Virtual Chassis Commands
Command Description
show edp Displays connectivity information for neighboring
Summit switches.
enable summitlink port Enables the port to connect to a SummitLink port
on the Summit Virtual Chassis. SummitLink cannot
be enabled if multiple STPDs are configured on
the port. The default setting is disabled.
disable summitlink port Disables the connection to the SummitLink port on
the Summit Virtual Chassis.
enable edp port Enables the generation and processing of Extreme
Discovery Protocol message on one or more ports.
The default setting is enabled.
disable edp port Disables the Extreme Discovery Protocol on one or
more ports. EDP cannot be disabled on a port that
has SummitLInk enabled.
Summit.bk : 4PORTS.FM Page 12 Thursday, June 18, 1998 9:27 AM