Extreme Networks Summit1 - Manual (Page 64)

3-16 S UMMIT S WITCH I NSTALLATION AND U SER G UIDE
A CCESSING T HE S WITCH
IP H
OST
C
ONFIGURATION
C
OMMANDS
Table 3-5 describes the commands that are used to configure IP settings on the switch.
Table 3-5: IP Host Configuration Commands
Command Description
config iparp add Adds a permanent entry to the ARP table.
Specify the IP address and MAC address
of the entry.
config iparp delete Deletes an entry from the ARP table.
Specify the IP address of the entry.
clear iparp [ | vlan | all] Removes dynamic entries in the IP ARP
table. Permanent IP ARP entries are not
affected.
config iproute add
{} Adds a static address to the routing table.
Use a value of 255.255.255.255 for
mask
to indicate a host entry
config iproute delete
Deletes a static address from the routing
table.
config iproute add default {} Adds a default gateway to the routing
table. A default gateway must be located
on a configured IP interface. If no metric is
specified, the default metric of 1 is used.
config iproute delete default Deletes a default gateway from the
routing table.
show ipconfig {vlan | all} Displays configuration information for one
or more VLANs.
show ipstats {vlan [ | all]} Displays IP statistics for the CPU of the
switch.
show iparp { | all |
permanent} Displays the IP ARP table. You can filter
the display by IP address, VLAN, or
permanent entries.
Summit.bk : 3MGMT.FM Page 16 Thursday, June 18, 1998 9:27 AM