Extreme Networks Summit1 - Manual (Page 202)

14-2 S UMMIT S WITCH I NSTALLATION AND U SER G UIDE
S OFTWARE U PGRADE AND B OOT O PTIONS
• Download the new image to the Summit using the command
download image [xmodem | ] {primary |
secondary}
where the following is true:
xmodem — Indicates that you will be using XMODEM over the serial port.
ipaddress — Is the IP address of the TFTP server.
filename — Is the filename of the new image.
primary — Indicates the primary image.
secondary — Indicates the secondary image.
The Summit can store up to two images: a primary and a secondary. When you
download a new image, you must select into which image space (primary or secondary)
you want the new image to be placed.
You can select which image the switch will load on the next reboot by using the
following command:
use image {primary | secondary}
If you do not specify which image to use, the switch automatically loads the primary
image.
R EBOOTING THE S WITCH
To reboot the switch, use the following command:
reboot { | cancel}
where date is the date and time is the time (using a 24-hour clock format) when the
switch will be rebooted. The values use the following format:
mm/dd/yyyy hh:mm:ss
If you do not specify a reboot time, the reboot happens immediately following the
command, and any previously scheduled reboots are cancelled. To cancel a previously
scheduled reboot, use the
cancel option.
Summit.bk : 14BOOT.FM Page 2 Thursday, June 18, 1998 9:27 AM