Extreme Networks Summit1 - Manual (Page 143)

S UMMIT S WITCH I NSTALLATION AND U SER G UIDE 9-13
C ONFIGURING DHCP/BOOTP R ELAY
Table 9-2 describes the commands used to configure the IP route table.
Table 9-2: Route Table Configuration Commands
Command Description
enable iproute sharing Enables load sharing if multiple routes to the
same destination are available. Only paths with
the same lowest cost are shared. The default
setting is enabled.
config ipqos add
qosprofile Adds a QoS profile to an IP destination
address.
config ipqos delete
Deletes a QoS profile from an IP destination
address.
config iproute add
Adds a static address to the routing table. Use
a value of 255.255.255.255 for
mask to
indicate a host entry
config iproute delete
Deletes a static address from the routing table.
config iproute add blackhole
Adds a blackhole address to the routing
table. All traffic destined for the configured IP
address is dropped, and no Internet Control
Message Protocol (ICMP) message is
generated.
config iproute delete blackhole
Deletes a blackhole address from the routing
table.
config iproute add default
{} Adds a default gateway to the routing table. A
default gateway must be located on a
configured IP interface. If no metric is
specified, the default metric of 1 is used.
config iproute delete default Deletes a default gateway from the routing
table.
disable iproute sharing Disables load sharing for multiple routes.
Summit.bk : 9ROUT.FM Page 13 Thursday, June 18, 1998 9:27 AM