Extreme Networks Summit1 - Manual (Page 38)

1-18 S UMMIT S WITCH I NSTALLATION AND U SER G UIDE
S UMMIT O VERVIEW
In addition, when connected to a Summit RPS or Summit Virtual Chassis, the Summit
switch can provide status on power and fan operation of the RPS through SNMP, the
command-line interface, and the Web interface (power supply status only).
The Summit RPS and Summit Virtual Chassis can simultaneously provide power for as
many as two Summit switches.
MAC A DDRESS
This label shows the unique Ethernet MAC address assigned to this device.
F ACTORY D EFAULTS
Table 1-4 shows factory defaults for the Summit features.
Table 1-4: Summit Factory Defaults
Item Default Setting
Port status Enabled on all ports.
Serial or Telnet user account admin with no password and user with no password.
Console port configuration 9600 baud, eight data bits, one stop bit, no parity,
XON/XOFF flow control enabled.
Web network management Enabled.
SNMP read community string public.
SNMP write community string private.
RMON history session Enabled.
RMON alarms Disabled.
BOOTP Enabled on the default VLAN ( default).
QoS All traffic is part of the default queue in ingress mode.
802.1p priority Recognition enabled.
802.3x flow control Enabled.
Virtual LANs One VLAN named default; all ports belong to the default
VLAN. The default VLAN belongs to the STPD named s0.
802.1Q tagging All packets are untagged on the default VLAN ( default).
Spanning Tree Protocol Disabled for the switch; enabled for each port in the STPD.
IP Routing Disabled.
Forwarding database aging period 300 seconds (5 minutes).
Summit.bk : 1OVRVW.FM Page 18 Thursday, June 18, 1998 9:27 AM