Extreme Networks Summit1 User Manual
Page 157
S
UMMIT
S
WITCH
I
NSTALLATION
AND
U
SER
G
UIDE
10-9
C
ONFIGURING
RIP
config rip add {vlan
Configures RIP on an IP interface. If no VLAN
is specified, then
all
is assumed. When an
IP interface is created, per interface RIP
configuration is disabled by default.
config rip delete [vlan
Disables RIP on an IP interface. When RIP is
disabled on the interface, the parameters are
not reset to their defaults.
config rip garbagetime {
Configures the RIP garbage time. The timer
granularity is 10 seconds. The default setting is
120 seconds.
config rip routetimeout {
Configures the route timeout. The timer
granularity is 10 seconds. The default setting is
180 seconds.
config rip rxmode [none | v1only | v2only |
any] {vlan
Changes the RIP receive mode for one or
more VLANs. Specify:
■
none
— Drop all received RIP packets.
■
v1only
— Accept only RIP version 1
format packets.
■
v2only
— Accept only RIP version 2
format packets.
■
any
— Accept both version 1 and version
2 packets.
If no VLAN is specified, the setting is applied to
all VLANs. The default setting is
any
.
config rip txmode [none | v1only | v1comp |
v2only] {vlan
Changes the RIP transmission mode for one or
more VLANs. Specify:
■
none
— Do not transmit any packets on
this interface.
■
v1only
— Transmit RIP version 1 format
packets to the broadcast address.
■
v1comp
— Transmit version 2 format
packets to the broadcast address.
■
v2only
— Transmit version 2 format
packets to the RIP multicast address
If no VLAN is specified, the setting is applied to
all VLANs. The default setting is
v2only
.
Table 10-1: RIP Configuration Commands (continued)
Command
Description
Summit.bk : 10PROT.FM Page 9 Thursday, June 18, 1998 9:27 AM