Extreme Networks Summit1 - Manual (Page 128)

8-8 S UMMIT S WITCH I NSTALLATION AND U SER G UIDE
Q UALITY OF S ERVICE (Q O S)
C
ONFIGURING
Q
O
S
Table 8-4 describes the commands used to configure QoS.
Table 8-4: QoS Configuration Commands
Command Description
enable pace Enables recognition of the PACE bit.
Available in ingress mode, only.
create qosprofile Creates a QoS profile. The default values
assigned to a created QoS profile are:
■
Minimum bandwidth — 0%
■ Maximum bandwidth — 100%
■
Priority — low
config qosmode [ingress | egress] Changes the QoS mode to ingress mode
or egress mode.
config qosprofile {minbw }
{maxbw } {priority } Configures a QoS profile. Specify:
■ minbw — The minimum bandwidth
percentage guaranteed to be available
to this queue. The default setting is 0.
■ maxbw — The maximum bandwidth
percentage this queue is permitted to
use. The default setting is 100.
■ priority — The service priority for
this queue. Settings include low,
medium-low, medium, high. The default
setting is low. Available in egress mode,
only.
config port qosprofile Allows you to configure one or more ports
to use a particular QoS profile. Available
in ingress mode, only.
config vlan qosprofile Allows you to configure a VLAN to use a
particular QoS profile.
disable pace Disables recognition of the PACE bit.
Available in ingress mode, only.
Summit.bk : 8QOS.FM Page 8 Thursday, June 18, 1998 9:27 AM