Manually configuring the ip settings – Extreme Networks Summit1 User Manual
Page 61
S
UMMIT
S
WITCH
I
NSTALLATION
AND
U
SER
G
UIDE
3-13
U
SING
T
ELNET
The switch MAC address is found on the rear label of the switch.
Once this is done, the IP address and subnetwork mask for the switch will be
downloaded automatically. You can then start managing the switch without further
configuration.
You can enable BOOTP on a per-VLAN basis by using the following command:
enable bootp vlan [
By default, BOOTP is enabled on the default VLAN.
If you configure the switch to use BOOTP, the switch IP address is not retained through
a power cycle, even if the configuration has been saved. To retain the IP address
through a power cycle, you must configure the IP address of the VLAN using the
command-line interface (CLI), Telnet, or Web interface.
All VLANs within a switch that are configured to use BOOTP to get their IP address
use the same MAC address. Therefore, if you are using BOOTP relay through a router,
the BOOTP server must be capable of differentiating its replay based on the gateway
portion of the BOOTP packet.
For more information on DHCP/BOOTP relay, refer to
M
ANUALLY
C
ONFIGURING
THE
IP S
ETTINGS
If you are using IP without a BOOTP server, you must enter the IP parameters for the
switch in order for the SNMP Network Manager or Telnet software to communicate
with the device. To assign IP parameters to the switch, you must do the following:
•
Log in to the switch with administrator privileges.
•
Assign an IP address and subnetwork mask to a VLAN.
The switch comes configured with a default VLAN named default. To use Telnet or
an SNMP Network Manager, you must have at least one VLAN on the switch, and it
must be assigned an IP address and subnetwork mask. IP addresses are always
assigned to a VLAN. The Summit can be assigned multiple IP addresses.
For information on creating and configuring VLANs, refer to
Summit.bk : 3MGMT.FM Page 13 Thursday, June 18, 1998 9:27 AM