Extreme Networks Summit1 - Manual (Page 156)

10-8 S UMMIT S WITCH I NSTALLATION AND U SER G UIDE
R OUTING P ROTOCOLS
C
ONFIGURING
RIP
Table 10-1 describes the commands used to configure RIP.
Table 10-1: RIP Configuration Commands
Command Description
enable rip Enables RIP. The default setting is disabled.
enable rip aggregation Enables RIP aggregation of subnet information
an interface configured to sent RIP v2 or RIP
v2-compatible traffic. The switch summarizes
subnet routes to the nearest class network
route. The following rules apply when using
RIP aggregation:
■
Subnet routes are aggregated to the
nearest class network route when crossing
a class boundary.
■
Within a class boundary, no routes are
aggregated.
■
If aggregation is enabled, the behavior is
the same as in RIP v1.
■
If aggregation is disabled, subnet routes
are never aggregated, even when crossing
a class boundary.
The default setting is enabled.
enable rip exportstatic Enables the advertisement of static routes
using RIP. The default setting is enabled.
enable rip poisonreverse Enables the split horizon with poison-reverse
algorithm for RIP. The default setting is
enabled. If you enable poison reverse and
split horizon, poison reverse takes precedence.
enable rip splithorizon Enables the split horizon algorithm for RIP.
Default setting is enabled.
enable rip triggerupdate Enables triggered updates. Triggered updates
are a mechanism for immediately notifying a
router’s neighbors when the router adds or
deletes routes, or changes the metric of a
route. The default setting is enabled.
Summit.bk : 10PROT.FM Page 8 Thursday, June 18, 1998 9:27 AM