Extreme Networks Summit1 - Manual (Page 101)

S UMMIT S WITCH I NSTALLATION AND U SER G UIDE 5-15
C ONFIGURING VLAN S ON THE S UMMIT
enable ignore-stp vlan Enables a VLAN from using STP port
information. When enabled, all virtual ports
associated with the VLAN are in STP
forwarding mode. The default setting is
disabled.
config dot1p ethertype Configures an IEEE 802.1Q Ethertype. Use
this command only if you have another switch
that supports 802.1Q, but uses a different
Ethertype value than 8100.
config protocol [add | delete]
{ } ... Configures a protocol filter. Supported
<
protocol_typ e> values include:
■ etype
■ llc
■ snap
The variable < hex_value > is a hexadecimal
number between 0 and FFFF that represents
either the Ethernet protocol type (for
EtherType), the DSAP/SSAP combination (for
LLC), or the SNAP-encoded Ethernet protocol
type (for SNAP).
config vlan ipaddress
{} Assigns an IP address and an optional mask to
the VLAN.
config vlan [add | delete] port
{tagged | untagged} Adds one or more ports to a VLAN. You can
specify tagged port(s), untagged port(s). By
default, ports are untagged.
config vlan delete port
{tagged | untagged} Deletes one or more ports from a VLAN.
config vlan protocol
[ | any] Configures a protocol-based VLAN. If the
keyword
any is specified, then it becomes the
default VLAN. All packets that cannot be
classified into other protocol-based VLANs are
assigned to the default VLAN of that port.
config vlan qosprofile Configures a VLAN to use a particular QoS
profile. Dynamic FDB entries associated with
the VLAN are flushed once the change is
committed.
config vlan tag Assigns a numerical VLANid. The valid range
is from 1 to 4095.
Table 5-2: VLAN Configuration Commands (continued)
Command Description
Summit.bk : 5VLAN.FM Page 15 Thursday, June 18, 1998 9:27 AM