Extreme Networks Summit1 - Manual (Page 199)

S UMMIT S WITCH I NSTALLATION AND U SER G UIDE 13-5
S AVING C HANGES
S TATUS M ESSAGES
Status messages are displayed at the top of the content frame. There are four types of
status messages, as follows:
• Information—Displays information that is useful to know prior to, or as a result of,
changing configuration options.
• Warning—Displays warnings about the switch configuration
• Error—Displays errors caused by incorrectly configured settings
• Success—Displays informational messages after you click Submit. The message
displayed reads, “Request was submitted successfully.”
S TANDALONE B UTTONS
At the bottom of some of the content frames is a section that contains standalone
buttons. Standalone buttons are used to perform tasks that are not associated with a
particular configuration option. An example of this is the Reboot Switch button.
S
AVING
C
HANGES
There are two ways to save your changes to non-volatile RAM storage using
ExtremeWare Vista:
• Select Save Configuration from the Configuration task tab, Switch option.
This field contains a drop-down list box that allows you to select either the primary
or secondary configuration area. After you select the configuration area, click Submit
to save the changes.
For more information on the primary and secondary configuration areas, refer to
Chapter 14 .
Selected non-contiguous items Hold down [Control], click the first
desired item, click the next desired
item, and so on.
Table 13-1: Multi-Select List Box Key Definitions (continued)
Selection Type Key Sequence
Summit.bk : 13VISTA.FM Page 5 Thursday, June 18, 1998 9:27 AM