Extreme Networks Summit1 - Manual (Page 163)

S UMMIT S WITCH I NSTALLATION AND U SER G UIDE 10-15
C ONFIGURING OSPF
config ospf delete virtual-link
Removes a virtual link.
config ospf area normal Configures an OSFP area as a normal area.
The default setting is
normal .
config ospf area stub [summary |
nosummary] stub-default-cost Configures an OSPF area as a stub area. The
default setting is
normal .
config ospf area add range
[advertise | noadvertise] Configures a range of IP addresses in an
OSPF area. If advertised, the range is exported
as a single summary link state advertisement
by the ABR.
config ospf area delete range
Deletes a range of IP addresses in an OSPF
area.
config ospf routerid [automatic | ] Configures the OSPF router ID. If automatic is
specified, the switch uses the largest IP
interface address as the OSPF router ID. The
default setting is automatic.
config ospf [vlan | area |
virtual-link ] timer
Configures the timers for one interface or all
interfaces in the same OSPF area. The
following default, minimum, and maximum
values (in seconds) are used:
■ Retransmission interval
Default: 5
Minimum: 0
Maximum: 3600
■ Transmission delay
Default: 1
Minimum: 0
Maximum: 3600
■ Hello interval
Default: 10
Minimum: 1
Maximum: 65535
■ Dead interval
Default: 40
Minimum: 1
Maximum: 2147483647
Table 10-4: OSPF Configuration Commands (continued)
Command Description
Summit.bk : 10PROT.FM Page 15 Thursday, June 18, 1998 9:27 AM