Yaskawa i80M Connecting Manual - Manual (Page 269)

21.3.2.10 WAIT M COMMAND #30450)
With this input, it is possible to disregard a wait command in cases where the internal M code
instructs the machine to wait for an interval between programs of a multi-program system. This
feature is used to individually check one program of a multi-program system.
Table 21.16 Wait M Command Disregard Input
Disregards the wait M command for the in-
terval between the first program and the
input-signal-relevant program.
Note: The relevant program contains the input signal.
21.3.2.11 USER MACRO INTERFACE 1/0 SIGNAL SYSTEM VARIABLES # 30460
# 30497, # # 35430)
(1) When an interface input system variable ( # 1000-# 1031) is designated for the right-hand
side of an operational expression, the ON/OFF states of the 32-point input signals specialized
for the microprogram are read. The relationship between the input signals and system vari-
ables is indicated in Table 21.17.
(2) When an interface output system variable ( # 1100-# 1131) is designated for the left-hand
side of an operational expression, the ON/OFF states of the 32-point output signals special-
ized for the microprogram are read.
The relationship between the output signals and sys-
tem variables is indicated in Table 21.18.
269