Yaskawa i80M Connecting Manual - Manual (Page 152)

20.2.37 EXTERNAL INPUT, EXTERNAL VERIFICATION,
EVER, EOUT, ECLM, IER, EDTS)
These external signals are used to perform part program
tions relative to the part program memory in the NC.
NC CPU UNIT
AND EXTERNAL OUTPUT SIGNALS
input, verification, and output
#30110 EIN
EXTERNAL INPUT
❑
I + 2 4 v
WARNING
# 35004 WARNS
EDITING STATE
#35012 EDTS
I
Fig. External External Verification, and External
Output Signals
External Input
When the EIN input is closed in the label skip state, the part program storage operation is per-
formed via the interface defined by the
equipment no matter what mode the NC is in.
The part program to be stored must be formatted as indicated in Fig. 20.14.
PROGRAM NUMBER (ONE BLOCK ONLY)
CODE)
< — P A R T P R O G R A M M 3 0 C R E R
(ISO CODE) ; ‘
< P R O G R A M
(OR M 02)
I ‘ -
GENERICALLY CALLED “EOB CODE” OR “END-OF-BLOCK CODE”
‘ - GENERICALLY “R “REWIND-STOP CODE
Fig. 20.14 Formatting the Program to Be Stored
Program registration is carried out according to the program number (O number) attached to the
beginning of a part program.
Program storage is completed when the NC reads the FOR code (ER or %) which is attached to
the end of a program.
152