Yaskawa i80M Appendix - Manual (Page 253)

Parameter No. N A M E
#401 1 MABIN MANINC MANAXS G45HD
(Bit No. 6 5 4 3 2 1 o )
Manual absolute function not disregarded relative to
incremental commands.
Disregards manual absolute function relative to
incremental commands.
Manual absolute valid when there is an axis command
in a block in which no incremental amount is generated.
absolute invalid when there is an axis command
in a block in which no incremental amount is generated.
absolute valid when there is no axis command
in a block in which incremental amount is generated.
Manual absolute invalid when there is no axis command
in a block in which incremental amount is generated.
G45 to G48 offset number command is possible with
D code only.
G45 to G48 offset number command is possible with
H code only.
– 2 5 3 –