Yaskawa i80M Appendix - Manual (Page 157)

Parameter No. N A M E
SREVMD 10IN
(Bit No. 6 5 3 2 1 o )
1 :
1 :
Parameter No.
SAGR not checked when changing from rapid traverse
to cutting feed.
SAGR checked when changing from rapid traverse to
cutting feed.
Outputs O with SSTP “O” spindle S command O input.
Outputs O with SSTP “ 1” spindle S command O input.
Displays value calculated from command S for spindle
actual r/rein indication.
Displays feedback from spindle motor for spindle
actual r/rein indication.
Applies no override to spindle r/rein output.
Applies override to spindle r/rein output.
Sets input to minimum input unit.
Sets input to 10 times the minimum input unit.
N A M E
(Bit No. 6 5 4 3 2 1
m
– 1 5 7 –