Yaskawa i80M Appendix - Manual (Page 230)

9.2 PARAMETER NUMBER TABLE (Cent’d)
Parameter No. N A M E
ATCOSP RUNSEL EDPWOF INTDSP3 DSPSEL1 DSPSELO
(Bit No. 7 6 5 4 3 2 1
A T C D S P
1 :
m “ ’
ATC display setting is made by byte
ATC display setting is made by word.
Does not display spindle tool and next tool in operation
process program display.
Displays spindle tool and next tool in operation process
program display.
Can reset an alarm confirmation requested program.
Resets an alarm confirmation requested program after
troubleshooting.
Input setting at power ON is to be absolute input.
Input setting at power ON is to be incremental input.
Preparation process display at power ON is to be work
coordinate system job.
Preparation process display at power ON is to be tool job.
D1 DO
o 0 4-position screen
Power-on
Initial Screen
o 1 Program check screen
Selection
1 0 Editing screen
1 1 4-position screen
– 2 3 0 –