Yaskawa i80M Appendix User Manual
Page 232
9.2 PARAMETER NUMBER TABLE (Cent’d )
Parameter No.
N A M E
#3005
ONOALT
CLNO
M02M99
PONON
(Bit
7
6
5
4
3
2
1
o
)
1 :
1 :
1 :
1 :
Does not change registered O-number when
number in the program is changed in editing display.
Changes registered O-number when O-number in the
program is changed in editing display.
Code “:” of 1S0 codes not converted to “O” during tape
input.
Code “:” of 1S0 codes converted to “O” during tape
input.
No automatic edit for O number when program’ rename,
copy and store are executed.
Edits automatically for O number when program
rename, copy and store are executed.
Does not consider completed M code
as program end when loading tape.
Considers completed M code
as
program end when loading tape.
Considers program No. as a numerical value following
o.
program No. as the numerical value
following O or N.
Clears program number after power is switched on.
Does not clear program number after power is
switched on.
Warning issued if there is already a O when loading a
tape.
Erases program and writes if there is already a O when
loading a tape.
NC data peculiar control is not provided at 1/0 verifica-
tion, #3005 DO and D2 to D5 are all treated as “O”
disregarding parameter values.
data peculiar control parameter (l: Provided, O: Not pro-
vided)
1st port input #0012 D7 1st part output #0014 D7
2nd port input #0017 D7 2nd port output #0019 D7
– 2 3 2 –