Yaskawa i80M Appendix - Manual (Page 233)

Parameter No. N A M E
COMPRT3 COMPRT1 CARA COMERR NCDEV
(Bit No. 7 6 5 4 3 2
D6 D5
cation o 0 1 Protocol 2
Module o 1 0 Protocol 3
Protocol
O : Control character not sent
1 : Control character sent
o )
Parameter No.
NC alarm occurs at communication module error.
NC alarm does not occur at communication module
error.
Tape operation device is selected by input from 1/0 port.
Tape operation device is selected by setting.
N A M E
#3007
(Bit No. 7 6 5 4 3 2 1
Communication module does not buffer 150 bytes of
DAT binary data after WAT command.
Communication module buffers 150 bytes of DAT
binary data after WAT command.
As usual.
Only TIME OUT ERROR is not output at #3006
= 1.
– 2 3 3 –