Yaskawa i80M Appendix - Manual (Page 135)

Parameter No. N A M E
#ooo7 BUZON PRMOOUT TLCNTE SK IPON UMSBK
(Bit No. 7 6 5 4 3 2 1 o )
O : Does not emit sound from operator panel buzzer.
1: Emits sound from operator panel buzzer.
O : Outputs data O when outputting parameters.
1 : Outputs data O when outputting parameters.
O : Data not displayed on screen at tape 1/0 collation.
1: Data displayed on screen at tape 1/0 collation.
O : Life management executed at T command.
1: Life management not executed at T command.
O : Work coordinate shift correction amount not added.
1: Work coordinate shift correction amount added.
O : Alarm occurs if skip signal does not go ON until end
of skip function block movement.
1: Alarm if skip signal does not go ON until end of
skip function block movement.
O : Operation command and control command in the user
macro program do not stop in a single block.
1: operation command and control command in the user
macro program stop in a single block .
O : Changes input unit to millimeters.
1: Changes input unit to inches.
Reset is required.
– 1 3 5 –