Yaskawa J1000 Compact V/f Control Drive User Manual
Yaskawa ac drive-j1000, Quick start guide, Compact v/f control drive
Table of contents
Document Outline
- Front Cover
- Table of Contents
- i Preface & General Safety
- 1 Receiving
- 2 Mechanical Installation
- 3 Electrical Installation
- 3.1 Section Safety
- 3.2 Standard Connection Diagram
- 3.3 Main Circuit Connection Diagram
- 3.4 Terminal Block Configuration
- 3.5 Protective Covers
- 3.6 Main Circuit Wiring
- 3.7 Control Circuit Wiring
- 3.8 I/O Connections
- 3.9 Main Frequency Reference
- 3.10 Braking Resistor
- 3.11 Interlocking with Connected Machinery
- 3.12 Wiring Checklist
- 4 Start-Up Programming & Operation
- 4.1 Section Safety
- 4.2 Using the Digital LED Operator
- 4.3 The Drive and Programming Modes
- 4.4 Start-up Flowchart
- 4.5 Basic Operation
- Initialize Parameter Values: A1-03
- Frequency Reference Source: b1-01
- Run Command Input Selection: b1-02
- Stopping Method Selection: b1-03
- Acceleration/Deceleration: C1-01 to C1-04
- Drive Duty and Carrier Frequency Selection: C6-01 and C6-02
- Multi-Step Speed Operation (4-Step Speed)
- E1: V/f Characteristics
- Motor Parameters: E2-01 to E2-03
- Digital Output: H2-01
- Analog Outputs: H4-01 to H4-03
- Motor Protection: L1-01 and L1-02
- Drive Status Monitors: U1-01 to U4-13
- 4.6 Powering Up the Drive
- 4.7 No-Load Operation Test Run
- 4.8 Test Run with Load Connected
- 4.9 Verifying and Backing Up Parameter Settings
- 4.10 Test Run Checklist
- 5 Troubleshooting
- 6 Periodic Inspection & Maintenance
- 7 Peripheral Devices & Options
- 7.1 Section Safety
- 7.2 Drive Options and Peripheral Devices
- 7.3 Connecting Peripheral Devices
- 7.4 Installing Peripheral Devices
- Installing a Molded Case Circuit Breaker (MCCB) and Earth Leakage Circuit Breaker (ELCB)
- Application Precautions when Installing a GFCI
- Installing a Magnetic Contactor
- Connecting an AC Reactor or DC Link Choke
- Connecting a Surge Suppressor
- Connecting a Noise Filter
- EMC Filter Installation
- Zero-Phase Reactor
- Installing Fuses on the Input Side
- Attachment for External Heatsink
- Noise Filter Installation
- Installing a Motor Thermal Overload (oL) Relay on the Drive Output
- NEMA Type 1 Kit
- 7.5 Options
- Appendix: A Specifications
- Appendix: B Parameter List
- Appendix: C Standards Compliance
- Index
- Revision History
- Back Cover