Wiring the main circuit terminal – Yaskawa J1000 Compact V/f Control Drive User Manual

Page 51

Wiring the Main Circuit Terminal

WARNING! Electrical Shock Hazard. Shut off the power supply to the drive before wiring the main circuit

terminals. Failure to comply may result in death or serious injury.

Note:

A cover placed over the DC Bus and braking circuit terminals prior to shipment helps prevent miswiring.

Cut away covers as needed for terminals with a needle-nose pliers.

A – Protective Cover to Prevent Miswiring

Main Circuit Connection Diagram

Refer to section

for drive main power

circuit connections.

WARNING! Fire Hazard. The braking resistor connection terminals are B1 and B2. Do not connect braking

resistors to any other terminals. Improper wiring connections could cause the braking resistor to overheat

and cause death or serious injury by fire. Failure to comply may result in damage to the braking circuit or

drive.

3.6 Main Circuit Wiring

YASKAWA ELECTRIC TOEP C710606 26D YASKAWA AC Drive – J1000 Quick Start Guide

Electrical Installation