Yaskawa J1000 Compact V/f Control Drive - Manual (Page 183)

<2> The Interface Option Unit can be directly connected to a PC with a D-sub 9-pin connector.
Use a cable designed for PC use (Yaskawa part number WV103).
Note: If the drive is set to trigger an output terminal when performing a fault restart (L5-02 = 1), the power
supply will be shut off during fault restart as the drive outputs a fault signal. Keep this in mind when
designing a wiring sequence to interrupt the power to the drive. The default setting for the drive is to not
trigger an output terminal that indicates a fault restart is being performed (L5-02 = 0).
7.3 Connecting Peripheral Devices
YASKAWA ELECTRIC TOEP C710606 26D YASKAWA AC Drive – J1000 Quick Start Guide 183
7
Peripheral Devices & Options