HEIDENHAIN iTNC 530 (340 49x-05) - Manual (Page 642)

642 Tables and Overviews
1
8
.3 T
e
c
hnical Inf
o
rm
ation
Accessories
Electronic handwheels „ One HR 420 portable handwheel with display or
„ One HR 410 portable handwheel or
„ One HR 130 panel-mounted handwheel or
„ Up to three HR 150 panel-mounted handwheels via HRA 110 handwheel adapter
Touch probes „ TS 220: 3-D touch trigger probe with cable connection, or
„ TS 440: 3-D touch trigger probe with infrared transmission
„ TS 444: Battery-free 3-D touch trigger probe with infrared transmission
„ TS 640: 3-D touch trigger probe with infrared transmission
„ TS 740: High-precision 3-D touch trigger probe with infrared transmission
„ TT 140: 3-D touch trigger probe for workpiece measurement
Software option 1
Rotary table machining „ Programming of cylindrical contours as if in two axes
„ Feed rate in mm/min
Coordinate transformation „ Tilting the working plane
Interpolation „ Circle in 3 axes with tilted working plane
Software option 2
3-D machining „ Motion control with minimum jerk
„ 3-D tool compensation through surface normal vectors
„ Using the electronic handwheel to change the angle of the swivel head during program
run without affecting the position of the tool point (TCPM = Tool Center Point
Management)
„ Keeping the tool normal to the contour
„ Tool radius compensation normal to the direction of traverse and the tool direction
„ Spline interpolation
Interpolation „ Linear in 5 axes (subject to export permit)
Block processing time „ 0.5 ms
DXF converter software option
Extracting contour programs
and machining positions from
DXF data „ Format supported: AC1009 (AutoCAD R12)
„ For plain-language and smarT.NC
„ Simple and convenient specification of reference points