HEIDENHAIN iTNC 530 (340 49x-05) - Manual (Page 599)

HEIDENHAIN iTNC 530 599
1
7.6 Ether
n
et Int
e
rf
ace
OPTIONS for
FILESYSTEMTYPE=
nfs Data without spaces, separated by
commas, and written in sequence. Switch
between upper and lower case letters.
RSIZE=
: Packet size in bytes for data
reception. Input range: 512 to 8192
WSIZE=
: Packet size in bytes for data
transmission. Input range: 512 to 8192
TIME0=
: Time in tenths of a second, after
which the TNC repeats a Remote
Procedure Call not answered by the server.
Input range: 0 to 100 000. If there is no
entry, the standard value 7 is used. Use
higher values only if the TNC must
communicate with the server through
several routers. Ask your network
specialist for the proper value.
SOFT=
: Definition of whether the TNC
should repeat the Remote Procedure Call
until the NFS server answers.
“soft” entered: Do not repeat the Remote
Procedure Call.
“soft” not entered: Always repeat the
Remote Procedure Call.
OPTIONS for
FILESYSTEMTYPE=
smb for direct
connection to
Windows networks Data without spaces, separated by
commas, and written in sequence. Switch
between upper and lower case letters.
ip=
: IP address of PC to which the TNC is
to be connected
username=
: User name under which the
TNC is to log on
workgroup=
: Work group under which the
TNC is to log on
password=
: Password with which the TNC
is to log on (up to 80 characters)
AM Definition of whether the TNC upon
switch-on should automatically connect
with the network drive.
0: Do not automatically connect
1: Connect automatically
The entries username, workgroup and password in the
OPTIONS column may not be necessary in Windows 95
and Windows 98 networks.
With the ENCODE PASSWORD soft key, you can encode
the password defined under OPTIONS.
Setting Meaning