HEIDENHAIN iTNC 530 (340 49x-05) - Manual (Page 105)

HEIDENHAIN iTNC 530 105
3.2 Cr
eating and W
riting Pr
ogr
a
ms
Editing a program
While you are creating or editing a part program, you can select any
desired line in the program or individual words in a block with the
arrow keys or the soft keys:
You cannot edit a program while it is being run by the TNC
in a machine operating mode. The TNC allows you to place
the cursor in the block, but it does not save the changes
and responds instead with an error message.
Function Soft key/Keys
Go to previous page
Go to next page
Go to beginning of program
Go to end of program
Change the position of the current block on the
screen: Press this soft key to display additional
program blocks that are programmed before
the current block.
Change the position of the current block on the
screen: Press this soft key to display additional
program blocks that are programmed after the
current block.
Move from one block to the next
Select individual words in a block
To select a certain block, press the GOTO key,
enter the desired block number, and confirm
with the ENT key. Or: Enter any number and
press the N LINES soft key to jump up or down
the entered number of lines.