HEIDENHAIN iTNC 530 (340 49x-05) - Manual (Page 164)

164 Programming: Tools
5.2 T
ool D
a
ta
Tool table: Tool data required for automatic tool measurement
For a description of the cycles governing automatic tool
measurement, see the User's Manual for Cycles
Abbr. Inputs Dialog
CUT Number of teeth (20 teeth maximum) Number of teeth?
LTOL Permissible deviation from tool length L for wear detection. If the
entered value is exceeded, the TNC locks the tool (status L).
Input range: 0 to 0.9999 mm Wear tolerance: length?
RTOL Permissible deviation from tool radius R for wear detection. If the
entered value is exceeded, the TNC locks the tool (status L).
Input range: 0 to 0.9999 mm Wear tolerance: radius?
R2TOL Permissible deviation from tool radius R2 for wear detection. If
the entered value is exceeded, the TNC locks the tool (status L).
Input range: 0 to 0.9999 mm Wear tolerance: Radius 2?
DIRECT. Cutting direction of the tool for measuring the tool during rotation Cutting direction (M3 = –)?
TT:R-OFFS For tool length measurement: Tool offset between stylus center
and tool center. Preset value: Tool radius R (NO ENT means R) Tool offset: radius?
TT:L-OFFS Tool radius measurement: Tool offset in addition to MP6530
between upper surface of stylus and lower surface of tool.
Default: 0 Tool offset: length?
LBREAK Permissible deviation from tool length L for breakage detection. If
the entered value is exceeded, the TNC locks the tool (status L).
Input range: 0 to 0.9999 mm Breakage tolerance: length?
RBREAK Permissible deviation from tool radius R for breakage detection. If
the entered value is exceeded, the TNC locks the tool (status L).
Input range: 0 to 0.9999 mm Breakage tolerance: radius?