HEIDENHAIN iTNC 530 (340 49x-05) - Manual (Page 21)

HEIDENHAIN iTNC 530 21
Chang
e
d functions with 340 49x
-04
Changed functions with 340 49x-04
„ DCM: Retraction after collision simplified (see “Collision monitoring
in the manual operating modes,” page 367)
„ The input range for polar angles was increased (see “Circular path
CP around pole CC” on page 215)
„ The value range for Q-parameter assignment was increased (see
“Programming notes,” page 276)
„ The pocket-, stud- and slot-milling cycles 210 to 214 were removed
from the standard soft-key row (CYCL DEF >
POCKETS/STUDS/SLOTS). For reasons of compatibility, the cycles
will still be available, and can be selected via the GOTO key
„ The soft-key rows in the Test Run operating mode were modified to
those of the smarT.NC operating mode
„ Windows XP is now used on the dual-processor version (see
“Introduction” on page 648)
„ Conversion from FK to H was moved to the special functions (SPEC
FCT) (see “Converting FK programs into HEIDENHAIN
conversational format” on page 224)
„ Filtering of contours was moved to the special functions (SPEC FCT)
(see “Filtering Contours (FCL 2 Function)” on page 405)
„ Loading of values from the pocket calculator was changed (see “To
transfer the calculated value into the program” on page 139)