HEIDENHAIN iTNC 530 (340 49x-05) - Manual (Page 20)

20
Chang
e
d functions with 340 49x
-03
Changed functions with 340 49x-03
„ In Cycle 22 you can now define a tool name also for the coarse
roughing tool (see User's Manual Cycles)
„ In the PLANE function, an FMAX can now be programmed for the
automatic rotary positioning (see “Automatic positioning:
MOVE/TURN/STAY (entry is mandatory)” on page 444)
„ When running programs in which non-controlled axes are
programmed, the TNC now interrupts the program run and displays
a menu for returning to the programmed position (see
“Programming of noncontrolled axes (counter axes)” on page 569)
„ The tool usage file now also includes the total machining time,
which serves as the basis for the progress display in percent in the
Program Run, Full Sequence mode (see “Tool usage test” on page
576)
„ The TNC now also takes the dwell time into account when
calculating the machining time in the Test Run mode (see
“Measuring the machining time” on page 559)
„ Arcs that are not programmed in the active working plane can now
also be run as spatial arcs (see “Circular path C around circle center
CC” on page 205)
„ The EDIT OFF/ON soft key on the pocket table can be deactivated
by the machine tool builder (see “Pocket table for tool changer” on
page 170)
„ The additional status display has been revised. The following
improvements have been introduced (see “Additional status
displays” on page 82):
„ A new overview page with the most important status displays
were introduced
„ The individual status pages are now displayed as tabs (as in
smarT.NC). The individual tabs can be selected with the Page soft
keys or with the mouse
„ The current run time of the program is shown in percent by a
progress bar
„ The tolerance values set in Cycle 32 are displayed
„ Active global program settings are displayed, provided that this
software option was enabled
„ The status of the Adaptive Feed Control (AFC) is displayed,
provided that this software option was enabled