HEIDENHAIN CNC Pilot 4290 - Manual (Page 94)

4 DIN PLUS 82
Example: CHUCKING EQUIPMENT table
SPANNMITTEL 1 [CHUCKING EQUIPMENT]
H1 ID”KH250”
H2 ID”KBA250-77”
. . .
4.4 Pr
ogr
am Section Codes
The chucking equipment table is used for
the simulation graphics – it does not
influence the execution of the program.
4.4.3 CHUCKING EQUIPMENT
CHUCKING EQUIPMENT x (x: 1 to 4) defines spindle assignment x.
Using the identification numbers of chuck, jaws and adapters (lathe
center, etc.), you create the chucking equipment table. It is evaluated
in the simulation (G65).
Enter chucking equipment data:
„Select ”Header – Chucking equipment”
Position the cursor in the CHUCKING EQUIPMENT section.
Press the INS key.
Edit the ”Chucking equipment” dialog box.
Edit the CHUCKING EQUIPMENT data:
Position the cursor.
Press ENTER
Edit the ”Chucking equipment” dialog box.
Parameters of the ”Chucking equipment” dialog box:
H:
Number of chucking equipment (reference to G65).
■ H=1: Chuck
■ H=2: Jaw
■ H=3: Adapter - spindle
■ H=4: Adapter - tailstock
ID: Identification number of chucking equipment (reference to
database).
X: Gripping diameter of jaws
Q: Chuck form of jaws (see G65)
4.4.4 Contour Definition
KONTUR [CONTOUR]
Assigns the following workpiece blank and finished part description to
a contour.
Parameters
Q:
Number of the contour – 1..4
X, Z: Zero point shift (reference: machine zero)
V: Position of the coordinate system
■ 0: The machine coordinate system applies
■ 2: Mirrored machine coordinate system (Z direction opposite
to the machine coordinate system)