HEIDENHAIN CNC Pilot 4290 - Manual (Page 431)

HEIDENHAIN CNC PILOT 4290 419
Operation
■ Vertical arrow keys; Page Up/Dn: move the cursor within the list of
files.
■ Arrow left/right: Switches between the left and right window – while
also switching the CNC PILOT between readiness to transmit and
receive
■ Enter character/character series: The cursor positions to the next
file name beginning with this character sequence
■ Enter (with DIN PLUS programs, parameters and operating
resource files): Shows the file content. You close the file by pressing
Enter again (or Esc).
Marks all displayed files – pressing again unmarks
them
This soft key or ”+” (plus key) marks the selected file –
pressing again unmarks it
■ Network or FTP: Marked files from the CNC PILOT to
the communications partner. If the file already exists,
you must answer the inquiry ”Overwrite?”.
■ Serial Transfer: Marked files are transmitted.
■ Network or FTP: Marked files are transferred from
the communications partner to the CNC PILOT. If the
file already exists, you must answer the inquiry
”Overwrite?”.
■ Serial Transfer: The CNC PILOT switches to readiness
to receive or receives data. If the file already exists,
you must answer the inquiry ”Overwrite?”.
■ Mouse operation: You can use a mouse to position the cursor, and
mark and open a file (with DIN PLUS programs, parameter files and
operating resource files).
1
0.3 D
ata
Tr
ansf
er
During serial transfer, first start the
receiver and then the transmitter.