HEIDENHAIN CNC Pilot 4290 - Manual (Page 90)

4 DIN PLUS 78
4
.3
The DIN PLUS Edit
or
”Edit” pull-down menu
■ Cut:
■ Stores the highlighted block in the clipboard.
■ Deletes the block.
■ Copy to clipboard – copies the highlighted block to the clipboard.
■ Paste from clipboard:
Position the cursor where you wish to insert the block.
Select ”Paste from clipboard.”
The block is inserted at the position indicated by the cursor.
■ Delete – deletes the highlighted block definitively (it is not stored in
the clipboard).
■ Displace:
Position the cursor where you wish to insert the block.
Select ”Displace.”
The highlighted block is moved from its initial position to the
position indicated by the cursor.
■ Copy and paste:
Position the cursor where you wish to insert the block.
Select ”Copy and paste.”
The block is inserted at/copied to the position indicated by the
cursor.
Single menu items
■ Cancel – all markings are canceled.
■ Insert contour – inserts the most recent workpiece blank and
finished part contour in the simulation below the cursor position
As an alternative of the block menu, you can use the usual
WINDOWS key combinations for marking, deleting, shifting etc.:
■ Marking by moving the cursor keys while holding the shift key.
■ Ctrl + C: Copy the marked text to the clipboard
■ Shift + Del(ete): Delete the marked text and save it in the clipboard
■ Ctrl + V: Insert text from the clipboard at the cursor position
■ Del(ete): Delete the marked text