HEIDENHAIN CNC Pilot 4290 - Manual (Page 354)

7 Parameters 342
General machine parameters (continued)
18 Control configuration
■ PLC takes over workpiece counting
■ 0: CNC takes over workpiece counting
■ 1: PLC takes over workpiece counting
■ M0/M1 for all NC channels
■ 0: M0/M1 initiates a STOP on programmed channels.
■ 1: M0/M1 initiates a STOP on all channels.
■ Stop interpreter during tool change
■ 0: Not active.
■ 1: Active; look-ahead block interpretation is interrupted and only
resumed after execution of the T command.
Slide parameters
204, 254, ... Feed rates
Rapid traverse speed and feed rate when slide is
moved with the axis-direction keys (jog keys).
■ Rapid traverse contouring speed for manual control
■ Feed rate contouring speed for manual control
205, 255, ... Protective-zone monitoring
The protection zone dimensions are defined for
individual axes (machine parameter 1116, ...). Define in
this parameter whether the protection zone
dimensions are to be monitored.
■ Monitoring
■ 0: Protection zone monitoring off
■ 1: Protection zone monitoring on
The other parameters are not used at present.
208, 258, ... Thread cutting
If the ”coupling/uncoupling path” is not programmed
in an NC program, parameter values are used.
■ Coupling path: Acceleration path at the beginning of a threading cut in
order to synchronize the feed axis with the spindle.
■ Decoupling path: Deceleration path at the end of a threading cut.
209, 259, ... Slide deactivation
■ Slide
■ 0: Deactivate slide.
■ 1: Do not deactivate slide.
7.2 Mac
hine P
a
ra
met
ers