HEIDENHAIN CNC Pilot 4290 - Manual (Page 367)

HEIDENHAIN CNC PILOT 4290 355
7.4 Set-Up P
a
ra
met
ers
Set-up parameters
Workpiece zero point
For each slide:
■ Workpiece zero point, main spindle (reference:
machine zero point)
■ Workpiece zero point, opposing spindle (reference:
machine zero point, opposing spindle)
”PgUp/PgDn” switches to the next/previous slides.
The ”Workpiece zero point, counterspindle” is derived
from ”Machine zero point - Zero offset” (machine
parameters 1114, 1164, ..). It is activated with ”G30
H1 ...”
■ Datum position, main spindle X, Y, Z – Slide 1
■ Datum position, main spindle X, Y, Z – Slide 2
. . .
■ Datum position, counterspindle X, Y, Z – Slide 1
■ Datum position, counterspindle X, Y, Z – Slide 2
. . .
Set the workpiece zero point in the Manual Control mode.
Tool change position
The CNC PILOT manages the tool change point for
each slide. ”PgUp/PgDn” switches to the next/
previous slides.
The tool change position defines the distance to the
machine zero point.
■ Tool change position X, Y, Z – Slide 1
■ Tool change position X, Y, Z – Slide 2
. . .
Set the workpiece zero point in the Manual Control mode.
7.4 Set-Up Parameters
Recommendation: Use ”Cur. Para– Set-
up (menu) – ... ” to edit the parameters. In
the other menu items the parameters are
listed without the axes.