HEIDENHAIN CNC Pilot 4290 - Manual (Page 220)

5 Graphic Simulation 208
5.6 Zoom Function
The zoom function can be used to magnify/reduce the
displayed graphic or isolate a detail.
Zoom settings by keyboard
Prerequisite: Simulation in ”stop condition”
When you call the zoom function, a red
frame appears with which you can
select the detail you wish to isolate.
With more than one simulation window:
Set the windows
Detail:
■ Enlarge: ”Page forward”
■ Reduce: ”Page back”
■ Shift: Cursor keys
Zoom settings by touch pad
Prerequisite: Simulation in ”stop condition”
Position the cursor to one corner of the section
While holding the left mouse key, pull the cursor to
the opposite corner of the section
Right mouse key: Return to standard size
Standard settings: See soft-key table
Exit the zoom function
After having enlarged a detail to a great extent, select
”Workpiece maximum” or ”Work space,” and then
isolate a new detail.
5.6 Zoom Function
Soft keys
Cancels the zoom settings and displays the last setting
(”Workpiece maximum” or ”Work space”).
Cancels the last magnification/setting. You can select
”Previous zoom” more than once.
Switches the zoom function to the next simulation
window.
Shows the workpiece in the largest possible view.
Shows the working space including the tool change
position.
Set the ”dimensions” of the simulation window and
position of the workpiece zero point. If there is more
than one window, each window must be set separately.
The setting applies to the contour of the selected slide.